FixVault
Home › Saturn › 2006 › Ion Red Line › Repair and Diagnosis › Steering › Steering Wheel & Steering Column › Repair Instructions › Ignition Switch Replacement › Installation Procedure

Installation Procedure

NOTE: Refer to Fastener Notice in Cautions and Notices.
Fig 1: View Of Ignition Switch
GM854768Courtesy of GENERAL MOTORS CORP.
  1. Install the ignition switch and screws on to the steering column.

    Tighten:  Tighten the screws to 2 N.m (17 lb in).

  2. Connect the ignition switch harness connector.
  3. Install the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
    IMPORTANT: If the ignition switch is replaced and a learn procedure is not performed, the engine will crank but not start or will start and stall immediately.
  4. Perform the vehicle theft deterrent system learn procedure. Refer to Programming Theft Deterrent System Components in Theft Deterrent.
About FixVault