FixVault
Home › Saturn › 2006 › Relay 3.5 L, AWD › Repair and Diagnosis › Engine Performance › System › Engine Controls - 3.5L - Introduction (2 Of 2) › Repair Instructions › Crankshaft Position Sensor Replacement › Removal Procedure

Removal Procedure

    Fig 1: View Of CKP Sensor (7X)
    GM15969Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Position the catalytic converter out of the way. Refer to Exhaust Seal Replacement .
  3. Disconnect the block heater electrical connector, if equipped.
  4. Disconnect the crankshaft position (CKP) sensor electrical connector.
  5. Remove the CKP sensor bolt.
  6. Remove the CKP sensor.
  7. Inspect for wear, cracks, or leakage if the sensor is not being replaced.
About FixVault