FixVault
Home › Saturn › 2006 › Relay 3.9 1, AWD › Repair and Diagnosis › Steering › Power Steering System › Repair Instructions › Power Steering Pressure Pipe/Hose Replacement › Installation Procedure

Installation Procedure

  1. Install the power steering pressure hose.
  2. Install the power steering hose to the hose retainer.
    3. Fig 1: View Of Power Steering Pressure Hose From The Power Steering Pump
    GM417974Courtesy of GENERAL MOTORS CORP.
  3. Install the power steering hose retainer to the power steering gear.
    4. Fig 2: View Of Power Steering Lines And Power Steering Gear
    GM417973Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  4. Connect the power steering hose to the steering gear.

    Tighten:  Tighten the fitting to 27 N.m (20 lb ft).

  5. Install the power steering gear hose clip.
  6. Install the power steering gear heat shield. Refer to Steering Gear Heat Shield Replacement .
  7. Lower the vehicle.
  8. Connect the power steering pressure hose to the pump.

    Tighten:  Tighten the fitting to 27 N.m (20 lb ft).

  9. Install the drive belt. Refer to Drive Belt Tensioner Diagnosis in Engine Mechanical - 3.5L.
  10. Bleed the power steering system. Refer to Power Steering System Bleeding .
About FixVault