FixVault
Home › Saturn › 2007 › Ion Red Line › Repair and Diagnosis (Single Page) › Body & Frame › Sun Roof/T-Top/Convertible Top › Sunroof System › Repair Instructions › Sunroof Module Assembly Replacement › Installation Procedure

Installation Procedure

    Fig 1: Sunroof Module To Roof Nut Tightening Sequence
    GM1610173Courtesy of GENERAL MOTORS CORP.
  1. With an assistant, position the new sunroof module assembly to the studs located on the roof ring.
  2. Install the center sunroof module to roof nuts (1, 2) and tighten by hand.
    3. NOTE: Refer to Fastener Notice .
  3. Install the remaining sunroof module (1) nuts to the module in sequence (3, 4, 5, 6, 7, 8).

    Tighten:  Tighten all of the nuts to 10 N.m (89 lb in).

    4. Fig 2: Sunroof Module Assembly
    GM1547329Courtesy of GENERAL MOTORS CORP.
  4. Connect the front and rear drain hoses (1) to the drain spouts on the sunroof module.
  5. Install the sunroof window to the new sunroof module. Refer to Sunroof Window Replacement .
  6. Install the sunshade panel to the new sunroof module. Refer to Sunroof Sunshade Replacement .
    7. Fig 3: View Of Sunroof Motor/Actuator Electrical Connector
    GM861204Courtesy of GENERAL MOTORS CORP.
  7. Connect the electrical connector to the sunroof motor/actuator.
  8. Secure the harness to the sunroof module.
  9. Verify the proper operation of the sunroof before securing the headliner.
  10. Install the headliner. Refer to Headlining Trim Panel Replacement (w/o Sunroof) or Headlining Trim Panel Replacement (with Sunroof) .
About FixVault