FixVault
Home › Saturn › 2007 › Ion Red Line › Repair and Diagnosis › Body & Frame › Sun Roof/T-Top/Convertible Top › Sunroof System › Repair Instructions › Sunroof Module Assembly Replacement › Removal Procedure

Removal Procedure

    IMPORTANT: A new sunroof module assembly does not include the sunroof window or the sunshade as components. You must install the old sunroof window and sunshade to the new sunroof module assembly.
    Fig 1: View Of Sunroof Motor/Actuator Electrical Connector
    GM861204Courtesy of GENERAL MOTORS CORP.
  1. Remove the sunshade panel. Refer to Sunroof Sunshade Replacement .
  2. Remove the sunroof window. Refer to Sunroof Window Replacement .
  3. Remove the headliner. Refer to Headlining Trim Panel Replacement (w/o Sunroof) or Headlining Trim Panel Replacement (with Sunroof) .
  4. Disconnect the electrical connector on the sunroof actuator.
  5. Disconnect the electrical connector from the sunroof module.
    6. Fig 2: Sunroof Module Assembly
    GM1547329Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the front and rear drain hoses (1) from the drain spouts on the sunroof module.
    7. IMPORTANT: Remove the 2 center nuts last in order to help support the sunroof module to the roof ring.
  7. Remove the sunroof module nuts (2) from the roof.
  8. Remove the center nuts from the sunroof module.
  9. With an assistant, lower and remove the sunroof module assembly out through the passenger side door.
About FixVault