Installation Procedure

WARNING: This page is about a different car, the 2005 Saturn Ion Red Line, 2005 Saturn Ion 3, 2005 Saturn Ion 2, and 2005 Saturn Ion 1. However, it is still accessible from the selected car via links, so may be relevant.

Install the HVAC control assembly.

Fig 1: View Of HVAC Control Assembly

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Install the HVAC control screws.
Tighten: Tighten the screws to 2.5 N.m (22 lb in).

IMPORTANT: Do not bend the mode and temperature cables.

Connect the mode and temperature cables to the HVAC control assembly.

Fig 2: View Of HVAC Control Assembly Mode & Temperature Cables

Courtesy of GENERAL MOTORS CORP.

Connect the HVAC control assembly electrical connectors.

Fig 3: View Of HVAC Control Assembly Electrical Connectors

Courtesy of GENERAL MOTORS CORP.

Place the radio in the vehicle and connect the radio electrical connectors.

Fig 4: View Of Radio Electrical Connectors

Courtesy of GENERAL MOTORS CORP.

Push the radio into position.
Install the radio screws.
Tighten: Tighten the screws to 2.5 N.m (22 lb in).

Fig 5: View Of Radio

Courtesy of GENERAL MOTORS CORP.

Connect the accessory trim plate electrical connector(s).

Fig 6: View Of Accessory Trim Plate Electrical Connectors

Courtesy of GENERAL MOTORS CORP.

Align the retaining fasteners with the I/P.

Fig 7: Instrument Panel Bezel/Trim Plate

Courtesy of GENERAL MOTORS CORP.

Push on the outer edge of the accessory trim plate in order to secure the retaining fasteners.