FixVault
Home › Saturn › 2007 › Ion Red Line › Repair and Diagnosis › External Pages › Different car › Section 16 (Antilock Brake System And Traction Control System) › Repair Instructions › Brake Pressure Modulator Valve (BPMV) Bracket Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Saturn Ion Red Line, 2004 Saturn Ion 3, 2004 Saturn Ion 2, and 2004 Saturn Ion 1. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the BPMV assembly bracket to the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the brake pressure modulator assembly bracket mounting nut and mounting bolts.

    Tighten: 

    • Tighten the nut to 25 N.m (18 lb ft).
    • Tighten the bolts to 25 N.m (18 lb ft).

    3. Fig 1: View Of BPMV Bracket
    GM890992Courtesy of GENERAL MOTORS CORP.
  3. Secure the forward lamp wiring harness retainer to the BPMV bracket.
    4. Fig 2: View Of Forward Lamp Wiring Harness At BPMV Bracket
    GM891778Courtesy of GENERAL MOTORS CORP.
  4. Install the brake modulator assembly to the bracket.
  5. Tighten the 2 brake pressure modulator assembly insulator nuts (1).

    Tighten:  Tighten the nuts to 8 N.m (71 lb in).

    6. Fig 3: Locating Brake Pressure Modulator Assembly Insulator Nuts
    GM890990Courtesy of GENERAL MOTORS CORP.
  6. Secure the EBCM wiring harness retainer to the BPMV bracket.
About FixVault