FixVault
Home › Saturn › 2007 › Ion Red Line › Repair and Diagnosis › External Pages › Different car › Section 20 (Engine Controls (Introduction)) › Repair Instructions › Ignition Coil(s) Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Saturn Ion Red Line. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Make sure that the ignition coil seals are properly seated to the valve cover.
  1. Install the ignition coil.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the ignition coil retaining bolts.

    Tighten:  Tighten the ignition coil retaining bolts to 10 N.m (89 lb in).

  3. Replace the ignition coil connectors.
  4. Install the ignition coil cover.
  5. Install the ignition coil cover screws.

    Tighten:  Tighten the screws to 8 N.m (71 lb in).

    6. Fig 1: View Of Ignition Coils
    GM1387190Courtesy of GENERAL MOTORS CORP.
About FixVault