FixVault
Home › Saturn › 2007 › Ion Red Line › Repair and Diagnosis › External Pages › Different car › Section 20 (Engine Controls (Introduction)) › Repair Instructions › Manifold Absolute Pressure (MAP) Sensor Replacement (SCIP) › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Saturn Ion Red Line. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the supercharger inlet pressure (SCIP) sensor harness connector.
  2. Remove the SCIP sensor (1) from the supercharger.
    3. IMPORTANT: If the SCIP sensor seal is damaged, the SCIP sensor must be replaced.
  3. Inspect the seal for damage.
    4. Fig 1: Locating SCIP Sensor & BARO Sensor
    GM1389393Courtesy of GENERAL MOTORS CORP.
About FixVault