FixVault
Home › Saturn › 2007 › Ion Red Line › Repair and Diagnosis › External Pages › Different car › Section 20 (Engine Controls (Introduction)) › Repair Instructions › Manifold Absolute Pressure (MAP) Sensor Replacement (TMAP) › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Saturn Ion Red Line. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the temperature manifold absolute pressure (TMAP) sensor harness connector.
  2. Remove the TMAP sensor from the intake manifold.
    3. IMPORTANT: If the TMAP sensor seal is damaged, the TMAP sensor must be replaced.
  3. Inspect the seal for damage.
    4. Fig 1: Locating TMAP Sensor
    GM1382191Courtesy of GENERAL MOTORS CORP.
About FixVault