FixVault
Home › Saturn › 2007 › Ion Red Line › Repair and Diagnosis › External Pages › Different car › Section 5 (Battery, Charging System And Starting System) › Repair Instructions › Generator Replacement (L61) › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Saturn Ion Red Line, 2004 Saturn Ion 3, 2004 Saturn Ion 2, and 2004 Saturn Ion 1. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the generator on the engine.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the generator bolts.

    Tighten:  Tighten the generator bolts to 22 N.m (16 lb ft).

    3. Fig 1: Identifying Generator Bolts
    GM758471Courtesy of GENERAL MOTORS CORP.
  3. Connect the positive battery harness to the generator battery terminal.

    Tighten:  Tighten the generator terminal nut to 20 N.m (15 lb ft).

  4. Connect the generator harness connectors.
  5. Install the air cleaner outlet resonator. Refer to Air Cleaner Outlet Resonator Replacement in Engine Controls - 2.2L (L61).
  6. Install the drive belt. Refer to Drive Belt Replacement in Engine Mechanical - 2.2L (L61).
  7. Connect the battery negative cable. Refer to Battery Negative Cable Disconnect/Connect Procedure .
About FixVault