FixVault
Home › Saturn › 2007 › Ion Red Line › Repair and Diagnosis › External Pages › Different car › Section 82 (Cellular Communication System) › Repair Instructions › Coupling Replacement - Antenna Inner › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Saturn Ion Red Line, 2005 Saturn Ion 3, 2005 Saturn Ion 2, and 2005 Saturn Ion 1. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean the inside of the rear window with an alcohol wipe.
    Fig 1: Cleaning and Drying Glass
    GM569466Courtesy of GENERAL MOTORS CORP.
  2. Dry the glass thoroughly using a lint free cloth.
    3. IMPORTANT:
    • You must use an adhesion promoter to assure adequate bonding of the coupling.
    • Mask off or protect areas before applying the adhesion promoter.
  3. Apply glass adhesion promoter GM P/N 12378555 (Canadian P/N 88901239) to the rear window in the area where you will install the antenna coupling. Follow the instructions on the product label.
    4. IMPORTANT:
    • The RF connections for the inner antenna coupling should run parallel to the defogger grid line.
    • Align the inner and the outer antenna couplings.
    • Do not touch the adhesive backing on the antenna coupling.
  4. Remove the protective film from the adhesive backing on the inner antenna coupling.
  5. Align the inner antenna coupling to the existing exterior coupling.
  6. Press firmly on all 4 corners and on the center of the antenna inner coupling (2) in order to ensure proper adhesion to the rear window (4). Hold pressure on the inner coupling (2) for 10-30 seconds.
    Fig 2: View Of Antenna & Inner Coupling
    GM650826Courtesy of GENERAL MOTORS CORP.
  7. Ensure that no gaps occur between the couplings (5, 2) and the rear window (4).
  8. Connect the coaxial cable to the inner coupling (2).
  9. Keep the vehicle dry. Allow 6-8 hours, at 15°C (60°F), for the adhesive to cure after installation.
About FixVault