FixVault
Home › Saturn › 2007 › Ion Red Line › Repair and Diagnosis › External Pages › Different car › Section 98 (Engine Controls - Introduction) › Repair Instructions › Accelerator Controls Pedal Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Saturn Ion 3, 2005 Saturn Ion 2, and 2005 Saturn Ion 1. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the upper attachment bolt into the APP assembly.
    2. Fig 1: View Of Accelerator Pedal Position Assembly
    GM898158Courtesy of GENERAL MOTORS CORP.
  2. Install the APP assembly into the vehicle.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the attachment bolts into the APP assembly.

    Tighten:  Tighten the accelerator pedal position assembly-to-brake bracket bolt to 9 N.m (80 lb in).

  4. Connect the APP sensor harness connector. Push the connector in until the lock position is felt, then pull back to confirm engagement.
  5. Install the APP sensor connect CPA.
About FixVault