FixVault
Home › Saturn › 2007 › Ion Red Line › Repair and Diagnosis › Restraints › Air Bag, SRS › Supplemental Inflatable Restraint System › Repair Instructions › Inflatable Restraint Roof Rail Module Replacement - Front › Installation Procedure

Installation Procedure

    Fig 1: View Of Roof Rail Module
    GM876377Courtesy of GENERAL MOTORS CORP.
  1. Install the inflator bracket tabs in the slots in the upper lock pillar sheet metal.
    2. NOTE: Refer to Fastener Notice.
  2. Install the inflator fastener.

    Tighten:  Tighten the fasteners to 10 N.m (89 lb in).

    3. IMPORTANT: Pull up on each snap-in fastener without depressing the locking tab to verify that the fastener is installed correctly.
  3. Install the rear tether snap-in fastener. Ensure that the fastener locks in place.
    4. Fig 2: View Of Tether Channel Push-In Fasteners
    GM876371Courtesy of GENERAL MOTORS CORP.
  4. Install the remaining snap-in fasteners.
  5. Install the tether channel push-in fastener.
    6. Fig 3: View Of Tether Snap-In Fastener
    GM876419Courtesy of GENERAL MOTORS CORP.
  6. Install the front tether snap-in fastener. Ensure that the fastener locks in place.
  7. Connect the electrical connector on the inflator.
  8. Install the electrical connector CPA.
  9. Install the headliner. Refer to Headlining Trim Panel Replacement (w/o Sunroof) or Headlining Trim Panel Replacement (with Sunroof) .
  10. Enable the SIR system. Refer to SIR Disabling and Enabling .
About FixVault