FixVault
Home › Saturn › 2007 › Relay 3.9 1 › Repair and Diagnosis › External Pages › Different car › Section 19 (Power Door Lock System And Release Systems) › Diagnostic Information and Procedures › Power Liftgate Inoperative › Component Testing › I/P Switch Assembly

I/P Switch Assembly

WARNING: This page is about a different car, the 2007 Saturn Outlook. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the I/P Switch Assembly.
  2. Test for infinite resistance between the signal circuit terminal 7 and the ground circuit terminal 3 with the liftgate open switch in the inactive position.
    • If not the specified value, replace the I/P Switch Assembly.
  3. Test for infinite resistance between the signal circuit terminal 8 and the ground circuit terminal 3 with the liftgate disable switch in the inactive position.
    • If not the specified value, replace the I/P Switch Assembly.
  4. Test for less than 3 ohms between the signal circuit terminal 7 and the ground circuit terminal 3 with the liftgate open switch in the active position.
    • If greater than the specified range, replace the I/P Switch Assembly.
  5. Test for less than 3 ohms between the signal circuit terminal 8 and the ground circuit terminal 3 with the switch in the disable position.
    • If greater than the specified range, replace the I/P Switch Assembly.
About FixVault