Component Testing

Driver Window Switch

1. Ignition OFF, disconnect the harness connector at the Driver Window switch.
2. Test for infinite resistance between the signal terminals G and H and the B+ circuit terminal C with the driver window switch in the INACTIVE position.
   • If less than infinite resistance, replace the Driver Window switch.
3. Test for less than 2 ohms of resistance between the signal terminal G and the B+ circuit terminal C with the driver window switch in the UP position.
   • If greater than 2 ohms, replace the Driver Window switch.
4. Test for less than 2 ohms of resistance between the signal terminal H and the B+ circuit terminal C with the driver window switch in the DOWN position.
5. If greater than 2 ohms, replace the Driver Window switch