Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac Montana SV6, 2007 Chevrolet Uplander, and 2007 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Battery & Cables

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Clean any existing corrosion from the battery terminal bolt flange and the battery cable end.

Install the negative battery cable to the battery.

NOTE: Refer to Fastener Notice .

Tighten the negative battery cable (2) nut.
Tighten: Tighten the nut to 16 N.m (12 lb ft).
Reprogram the radio presets. Refer to Radio Setup .
Re-initialize the power sliding doors. Refer to Rear Side Door Actuator Control Module Programming and Setup .