Installation Procedure

WARNING: This page is about a different car, the 2005 Saturn L300. However, it is still accessible from the selected car via links, so may be relevant.

Make sure the EGR valve mating surface is clean.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the EGR valve with a new gasket and new attachment bolts.
Tighten: Tighten the EGR valve bolts to 20 N.m (15 lb ft).

Fig 1: Removing/Installing EGR Valve

Courtesy of GENERAL MOTORS CORP.

Connect the EGR valve harness connector. Push the connector in until the lock position is felt, then pull back to confirm engagement.