FixVault
Home › Saturn › 2007 › Vue Red Line, AWD › Repair and Diagnosis › External Pages › Different car › Section 180 (General Information) › Introduction › Key and Lock Cylinder Coding › Lift Gate Lock Cylinder Coding › Balance of Assembly

Balance of Assembly

WARNING: This page is about a different car, the 2005 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Lift Gate Lock Cylinder Components
    GM1189819Courtesy of GENERAL MOTORS CORP.
  1. Insert cylinder (8) into housing (4).
    2. Fig 2: View Of Tumblers At Lock Cylinder
    GM1193709Courtesy of GENERAL MOTORS CORP.
  2. Place compressor springs (3) into head of cylinder (4).
    3. Fig 3: Placing Shutter Assembly Onto Cylinder
    GM1193706Courtesy of GENERAL MOTORS CORP.
  3. Place shutter assembly (3) onto cylinder by snapping legs of shutter into place of cylinder.
  4. Install the cap by aligning the notch in the cap with the large drain slot in the housing and pressing the cap until it bottoms out and snaps onto the housing.
    5. Fig 4: View Of Pawl & Retainer Clip
    GM1193700Courtesy of GENERAL MOTORS CORP.
  5. Install lever onto cylinder end and place clip (3) onto lever to hold lever. Clip is formed to fit into position.
  6. Place clip on lock assembly with legs up and snap over cylinder tail.
  7. Use a file push on legs to snap clip into correct position.
  8. Install rod clip onto lever by inserting small end into lever and forcing the clip to snap in tightly.
About FixVault