FixVault
Home › Saturn › 2007 › Vue Red Line, AWD › Repair and Diagnosis › External Pages › Different car › Section 409 (Supplemental Inflatable Restraint System) › Repair Instructions › Inflatable Restraint Sensing and Diagnostic Module Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: CPA Electrical Connectors, Nuts & SDM
    GM934648Courtesy of GENERAL MOTORS CORP.
  1. Install the nuts securing the rollover sensor to the floor panel.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Connect the electrical connectors.

    Tighten:  Tighten the nuts to 10 N.m (89 lb in).

  3. Install the console assembly. Refer to Console Replacement - Front Floor in Instrument Panel, Gages, and Console.
  4. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 8 .


Fig 1: View of The Sensing and Diagnostic Module
GM943648Courtesy of GENERAL MOTORS CORP.
  1. Remove any dirt, grease, or other contaminants from the mounting surface.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the SDM to the vehicle with the nuts.

    Tighten  Tighten the nuts to 10 Nm (89 lb in).

  3. Install the console assembly. Refer to Console Replacement - Front Floor in Instrument Panel, Gages, and Console.
  4. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 8  .
    IMPORTANT: If you do NOT perform the body control module (BCM) programming procedure, the vehicle option content information which is read by the BCM may be incorrect and a DTC B1001 Option Configuration Error will set in both the SDM and the BCM. This will illuminate the AIR BAG telltale.
  5. Reprogram the BCM. Refer to Body Control Module (BCM) Programming/RPO Configuration in Computer/Integrating Systems.
  6. Refer to Control Module References for programming and setup information.
About FixVault