FixVault
Home › Saturn › 2008 › Astra XE, Automatic › Repair and Diagnosis › Engine Performance › System › Engine Controls And Fuel - Introduction (2 Of 2) › Repair Instructions › Fuel Pressure Sensor Replacement › Installation Procedure

Installation Procedure

  1. Install the pressure sensor (atmospheric pressure).
    1. Connect wiring harness of pressure sensor (atmospheric pressure)
    2. Connect the wiring harness plug
    3. Attach the cable ties
    2. NOTE: Refer to Fastener Notice .
  2. Tighten the right rear wheel housing bolt.

    Tighten:  Tighten the bolt to 4 N.m (35 lb in).

  3. Install the right rear wheel housing inner paneling.

    Tighten: 

    • Tighten the 2 nuts to 2.5 N.m (22 lb in).
    • Tighten the 2 bolts to 2.5 N.m (22 lb in).

  4. Mount the right rear wheel.
  5. Lower the vehicle halfway.

    Tighten:  Tighten the right rear wheel to 110 N.m (81 lb ft).

About FixVault