FixVault
Home › Saturn › 2009 › Aura Green Line › Repair and Diagnosis › Body & Frame › Windows › Fixed And MOVEABLE Window System › Repair Instructions › Rear Window Replacement › Removal Procedure

Removal Procedure

WARNING: Refer to Cracked Window Warning .
    NOTE: Before cutting out a stationary window, apply a double layer of masking tape around the perimeter of the painted surfaces and inner trim.
  1. Remove the rear upper garnish moldings. Refer to Body Rear Corner Upper Garnish Molding Replacement .
  2. Disconnect the rear window radio antenna connector, if equipped.
  3. Disconnect the electrical connectors from the rear window defogger bus bars.
    4. WARNING: Refer to Defroster Outlet Warning .
  4. Cover the following parts to protect from the broken glass:
    • Upper dash pad
    • Defroster outlets and A/C outlets
    • Seats and carpeting
    5. WARNING: Refer to Glass and Sheet Metal Handling Warning .
    Fig 1: Separating Window From Urethane Adhesive
    GM71179Courtesy of GENERAL MOTORS CORP.
    NOTE: Keep the cutting edge of the tool against the window.
  5. Remove the window from the urethane adhesive.
    • Leave a base of urethane approximately 2 mm (0.078 in) on the pinch-weld flange.
    • The only suitable lubrication is clear water.
    • Use J 24402-A  , J 39032  , or equivalent in order to remove the window. See Special Tools .
    6. Fig 2: Removing Window From Vehicle
    GM1228676Courtesy of GENERAL MOTORS CORP.
  6. With the aid of an assistant, remove the window from the vehicle.
About FixVault