FixVault
Home › Saturn › 2009 › Sky Base, Standard › Repair and Diagnosis › External Pages › Different variant/trim › Section 2 (Engine Controls And Fuel - 2.0L - Introduction) › Repair Instructions › Manifold Absolute Pressure Sensor Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying MAP Sensor Connector
    GM1825525Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the engine wiring harness electrical connector (2) from the manifold absolute pressure (MAP) sensor.
    2. Fig 2: View Of MAP Sensor
    GM1828338Courtesy of GENERAL MOTORS CORP.
  2. Remove the MAP sensor bolts.
  3. Remove the MAP sensor and O-ring seal from the intake manifold.
About FixVault