FixVault

Removal Procedure

WARNING: This page is about a different car, the 2008 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Antenna Cable, Connectors & Clips
    GM800456Courtesy of GENERAL MOTORS CORP.
  1. Remove the rear sail panel. Refer to Sail Panel Replacement .
  2. Remove the rear assist handles. Refer to Assist Handle Replacement .
  3. NOTE: Use care when removing or installing the headliner. Excessive bending will damage the headliner.
  4. Lower the rear of the headliner.
  5. Remove the antenna cable from the clips (2, 3)
  6. Remove the antenna cable connection (1) from above the AM/FM antenna module.
  7. Remove the foam tape from the antenna cable connection (1).
  8. Disconnect the antenna connectors (1) from the radio antenna.
  9. Attach a piece of wire or string to the end of the antenna cable.
  10. Fig 2: View Of Antenna Cable & Connectors
    GM800461Courtesy of GENERAL MOTORS CORP.
  11. Remove the left rear compartment trim panel. Refer to Rear Compartment Side Trim Replacement - Left Side .
  12. Disconnect the antenna cable connection (1) from the digital receiver.
  13. Remove the antenna cable (2) from the clips and the rear harness.
  14. Pull the cable (2) through to the rear compartment.
  15. Remove the wire or string from the antenna cable (2).
  16. Remove the antenna cable (2) from the vehicle.