FixVault
Home › Saturn › 2009 › Vue Red Line, AWD › Repair and Diagnosis › External Pages › Different variant/trim › Section 9 (Engine Controls And Fuel - 3.5L - Introduction) › Repair Instructions › Accelerator Pedal Position Sensor Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: APP Sensor And Bolts
    GM1883847Courtesy of GENERAL MOTORS CORP.
  1. Position the APP sensor (2) against the brake pedal assembly.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the APP sensor bolts (1).

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

    3. Fig 2: Accelerator Pedal Position Sensor
    GM1883846Courtesy of GENERAL MOTORS CORP.
  3. Connect the instrument panel wiring harness electrical connector (2) to the APP sensor (1).
  4. Install the driver knee bolster reinforcement. Refer to Driver Knee Bolster Reinforcement Replacement .
About FixVault