FixVault
Home › Saturn › 2009 › Vue XE, 3.5 N › Repair and Diagnosis › Engine Performance › System › Engine Controls And Fuel - 3.5L - Introduction › Repair Instructions › Ignition Coil Replacement › Installation Procedure

Installation Procedure

    Fig 1: Ignition Coil Bracket
    GM1646089Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Install the ignition coil bracket studs, if necessary.

    Tighten:  Tighten the studs to 25 N.m (15 lb ft).

  2. Install the ignition coil assembly.
  3. Install the ignition coil bracket bolts/nuts.

    Tighten:  Tighten the bolts/nuts to 25 N.m (15 lb ft).

    4. Fig 2: Locating Right Side Spark Plug Wires & Ignition Coil
    GM1608803Courtesy of GENERAL MOTORS CORP.
  4. Connect the right side spark plug wires to the ignition coil.
    5. Fig 3: View Of Left Side Spark Plug Wires
    GM1608802Courtesy of GENERAL MOTORS CORP.
  5. Connect the left side spark plug wires to the ignition coil.
    6. Fig 4: View Of MAP Sensor Electrical Connector
    GM1608869Courtesy of GENERAL MOTORS CORP.
  6. Connect the ignition coil electrical connector (6).
  7. Connect the MAP sensor electrical connector (1).
  8. Install the air cleaner outlet duct, if required. Refer to Air Cleaner Outlet Duct Replacement .
About FixVault