FixVault
Home › Saturn › 2009 › Vue XE, 3.5 N › Repair and Diagnosis › Engine Performance › System › Engine Controls And Fuel - 3.5L - Introduction › Repair Instructions › Throttle Body Assembly Replacement › Removal Procedure

Removal Procedure

CAUTION: Do not use solvent of any type when cleaning the gasket surfaces on the intake manifold and the throttle body assembly, as damage to the gasket surfaces and throttle body assembly may result.
Use care in cleaning the gasket surfaces on the intake manifold and the throttle body assembly, as sharp tools may damage the gasket surfaces.
    Fig 1: Engine Wiring Harness Electrical Connector
    GM1883868Courtesy of GENERAL MOTORS CORP.
  1. Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
  2. Disconnect the engine wiring harness electrical connector (3) from the electronic throttle control (ETC) (2).
    3. Fig 2: View Of Upper Intake Manifold
    GM1775003Courtesy of GENERAL MOTORS CORP.
  3. Remove the throttle body bolts (9) and nuts (10).
  4. Remove the throttle body (8).
  5. Remove and discard the throttle body gasket (7).
About FixVault