FixVault
Home › Scion › 2004 › xA Automatic › Repair and Diagnosis › External Pages › Different car › Section 2425 (Engine Control System - DTCS P1148 To P2A03) › DTC P1564 ASCD Steering Switch › DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  1. If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next step.
    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.
  2. Turn ignition switch ON.
  3. Wait at least 10 seconds.
  4. Press MAIN switch for at least 10 seconds, then release it and wait at least 10 seconds.
  5. Press CANCEL switch for at least 10 seconds, then release it and wait at least 10 seconds.
  6. Press RESUME/ACCELERATE switch for at least 10 seconds, then release it and wait at least 10 seconds.
  7. Press SET/COAST switch for at least 10 seconds, then release it and wait at least 10 seconds.
  8. Check 1st trip DTC.
  9. If DTC is detected, go to "DIAGNOSTIC PROCEDURE ."
About FixVault