Section 375 (Generators & Regulators): Overhaul: Generator: Assembly
WARNING: This page is about a different car, the 2004 Scion xB. However, it is still accessible from the selected car via links, so may be relevant.
Use generator Pulley Set Nut Wrench Set (SST 09820-63010) to install generator pulley. Place SST "C" securely into a vise. Install SST "A" and "B" and generator into SST "C". See Figure. Tighten pulley nut in the opposite direction of disassembly. See TORQUE SPECIFICATIONS . Using 19 mm socket, slowly press in rectifier end frame. To complete assembly procedure, reverse disassembly procedure. After completing assembly, verify rotor turns smoothly.