Section 4 (Automatic Transaxle - Diagnostics): Initialization

WARNING: This page is about a different variant/trim than selected.

RESET MEMORY
CAUTION: Perform the RESET MEMORY (AT initialization) when replacing the automatic transaxle assy, engine assy or ECM.

NOTE: Hand-held tester only
1. Turn the ignition switch off.
2. Connect the hand-held tester to the DLC3.
3. Turn the ignition switch to the ON position.
4. Perform the reset memory procedure from the ENGINE menu.
  CAUTION: After performing the RESET MEMORY, be sure to perform the ROAD TEST described earlier.
  
  Fig 1: Identifying Tester Menu Flow Chart
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002