FixVault
Home › Scion › 2004 › xB Automatic › Repair and Diagnosis › Engine Performance › System › SFI System - Diagnosis › Stop Light Switch Circuit › Inspection Procedure

Inspection Procedure

  1. CHECK OPERATION OF STOP LIGHT 
    1. Check if the stop lights go on and off normally when the brake pedal is depressed and released.
    1. NG : REPAIR OR REPLACE STOP LAMP SWITCH CIRCUIT 
    2. OK : Go to next step. 
  2. READ VALUE OF HAND-HELD TESTER OR OBD II SCAN TOOL(STP SIGNAL AND ST1- VOLTAGE) 
    1. Turn the ignition switch ON.
    2. Select the item "DIAGNOSIS / ENHANCED OBD II / DATA LIST / ALL / STOP LIGHT SW" and read its value displayed on the hand-held tester or OBD II scan tool.

      Standard:: 

      BRAKE PEDAL SPECIFIED CONDITION

      Brake Pedal Specified Condition
      Depressed STP Signal ON
      Released STP Signal OFF
      Fig 1: Identifying Brake Pedal Motion Released And Depressed
      G03367782Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. OK : CHECK FOR INTERMITTENT PROBLEMS (See  CHECK FOR INTERMITTENT PROBLEMS   ) 
    2. NG : Go to next step. 
  3. INSPECT STOP LAMP SWITCH ASSY 
    1. Measure the resistance between terminals when the switch is ON and OFF.

      Standard: 

      STOP LAMP SWITCH SPECIFIED CONDITION

      Switch Position Tester Connection Specified Condition
      ON (Free) 1 - 2 Below 1 Ω
      OFF (Pushed in) 10 kΩ or higher
    1. NG : REPLACE STOP LAMP SWITCH ASSY 
      Fig 2: Inspecting Stop Lamp Switch Assembly
      G03367783Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. OK : Go to next step. 
  4. CHECK HARNESS AND CONNECTOR(STOP LAMP SWITCH - ECM) 
    1. Disconnect the S8 stop lamp switch connector.
    2. Disconnect the E4 ECM connector.
    3. Measure the resistance between the wire harness side connectors.

      Standard (Check for open): 

      STOP LAMP SWITCH - ECM SPECIFIED CONDITION (CHECK FOR OPEN)

      Tester Connection Specified Condition
      Stop lamp switch (S8-1) - STP (E4-19) Below 1 Ω

      Standard (Check for short): 

      STOP LAMP SWITCH - ECM SPECIFIED CONDITION (CHECK FOR SHORT)

      Tester Connection Specified Condition
      Stop lamp switch (S8-1) or STP (E4-19) - Body ground 10 kΩ or higher
      Fig 3: Identifying S8 Stop Lamp Switch Connector
      G03367784Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Reconnect the stop lamp switch connector.
    5. Reconnect the ECM connector.
    1. NG : REPAIR OR REPLACE HARNESS OR CONNECTOR 
      Fig 4: Identifying E4 ECM Connector
      G03367785Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. OK : REPLACE ECM (See ) 
About FixVault