Inspection Procedure

1. Disconnect the C6 connector.
2. Measure the resistance according to the value(s) in the table shown in COMBINATION METER TERMINAL RESISTANCE .

   Standard: 

   COMBINATION METER TERMINAL RESISTANCE
   
   

   Tester connection	Condition	Specified condition
   C6-1 - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the table shown in COMBINATION METER TERMINAL VOLTAGE .

   Standard: 

   COMBINATION METER TERMINAL VOLTAGE
   
   

   Tester connection	Condition	Specified condition
   C6-3 - Body ground	Always	10 to 14 V
   C6-4 - Body ground	Ignition switch ON	10 to 14 V

   Fig 1: Identifying Combination Meter Connector

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR CONNECTOR REPLACE HARNESS OR CONNECTOR 

OK: REPLACE COMBINATION METER ASSY (See  ON-VEHICLE INSPECTION  )