FixVault
Home › Scion › 2006 › tC Standard › Repair and Diagnosis › Transmission › Manual Trans › E350 Manual Transaxle › Transmission Control Cable › Installation

Transmission Control Cable: Installation

  1. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY 
    1. Install the control cable with the 2 bolts.

      Torque: 5.0 N.m (51 kgf.cm, 44 in. lbf) 

      Fig 1: Installing Control Cable With Bolts
      G04222477Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the clamp to the control cable.
    3. Install the clamp to the body with the 2 nuts.

      Torque: 5.0 N.m (51 kgf.cm, 44 in. lbf) 

      Fig 2: Installing Clamp To Body With Nuts
      G04222478Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Connect the control cable to the control cable bracket, and install 2 new clips.
    5. Connect the control cable to the transaxle, and install the 2 washers and 2 clips.
    Fig 3: Connecting Control Cable To Control Cable Bracket
    G04222479Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY 
    1. Connect the ends of the control cable and install the 2 clips to the shift lever.
    2. Turn the lock nuts of the shift cable 270°counterclockwise, and hold them in that position.
    3. Install the shift cable while holding them.
    4. Check that the cable are installed securely.
      Fig 4: Turning Lock Nuts Of Shift Cable
      G04222480Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Push in the cable locks of the shift cable and select cable.
  3. INSTALL FRONT NO. 1 FLOOR HEAT INSULATOR Torque: 5.5 N.m (56 kgf.cm, 49 in. lbf) 
  4. INSTALL EXHAUST PIPE ASSEMBLY (See  INSTALLATION  ) 
  5. INSTALL CENTER AIRBAG SENSOR ASSEMBLY 
  6. INSTALL AIR CONDITIONING UNIT ASSEMBLY (See  INSTALLATION  ) 
    Fig 5: Pushing Cable Locks Of Shift Cable And Select Cable
    G04222481Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. INSTALL REAR CONSOLE BOX ASSEMBLY (See  INSTALLATION  ) 
  8. INSTALL REAR CONSOLE PANEL SUB-ASSEMBLY UPPER (See  INSTALLATION  ) 
  9. INSTALL CONSOLE PANEL UPPER (See  INSTALLATION  ) 
  10. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (See  INSTALLATION  ) 
  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  12. PERFORM INITIALIZATION 
    NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
    1. Perform initialization (See INITIALIZATION ).
  13. CHECK SRS WARNING LIGHT 
    1. Check the SRS warning light (See TERMINALS OF ECU ).
About FixVault