How To Proceed With Troubleshooting

HINT:

• Use these procedures to troubleshoot the vehicle stability control system.
• *: Use the intelligent tester.

1. VEHICLE BROUGHT TO WORKSHOP 

   NEXT 

2. INSPECT BATTERY VOLTAGE 

   Standard voltage: 11 to 14 V 

   If the voltage is below 11 V, recharge or replace the battery before proceeding.

   NEXT 

3. CHECK AND CLEAR DTC* 

   NEXT 

4. PROBLEM SYMPTOM CONFIRMATION 

   Result 

   RESULT REFERENCE
   
   

   Result	Proceed to
   Symptom does not occur	A
   Symptom occurs	B

   B: Go to step   6 

   A: Go to Next Step 

5. SYMPTOM SIMULATION 

   NEXT 

6. CHECK FOR DTC* 

   Result 

   RESULT REFERENCE
   
   

   Result	Proceed to
   DTC is not output	A
   DTC is output	B

   B: Go to step   9 

   A: Go to Next Step 

7. PROBLEM SYMPTOMS TABLE 

   Result 

   RESULT REFERENCE
   
   

   Result	Proceed to
   Fault is not listed in PROBLEM SYMPTOMS TABLE	A
   Fault is listed in PROBLEM SYMPTOMS TABLE	B

   B: Go to step   9 

   A: Go to Next Step 

8. OVERALL ANALYSIS AND TROUBLESHOOTING 
   1. (see TERMINALS OF ECU  )
   2. (see DATA LIST / ACTIVE TEST  )

   NEXT 

9. CHECK FOR FLUID LEAKAGE 

   NEXT 

10. REPAIR OR REPLACE 

    NEXT 

11. CONFIRMATION TEST 

    NEXT: END