Unlock Warning Switch: Installation

INSTALL UNLOCK WARNING SWITCH ASSEMBLY
1. Install the unlock warning switch assembly.
2. Automatic transaxle:
  Connect terminals 3 and 4 of the unlock warning switch connector.
3. Connect the unlock warning switch assembly connector to the ignition switch.
  
  Fig 1: Identifying Warning Switch Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Manual transaxle:
  Secure the unlock warning switch wire harness to the steering column upper bracket with a new clamp as shown in the illustration.
  
  NOTE: Do not overtighten the clamp when securing the wire harness as the wire harness could be cut.
  
  Fig 2: Identifying Steering Column Upper Bracket With Clamp (Manual Transaxle)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Automatic transaxle:
  Secure the unlock warning switch wire harness to the steering column upper bracket as shown in the illustration.
  
  Fig 3: Identifying Steering Column Upper Bracket (Automatic Transaxle)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL STEERING COLUMN COVER
1. Install the steering column cover lower and steering column cover upper with the 2 screws.
  HINT:
  - Tilt the steering column assembly to the lowermost position when installing the steering column cover upper.
  - Tilt it to the uppermost position when installing the steering column cover lower.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION ).
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.