Front Speed Sensor Components: Removal

HINT:

• Use the same procedures for the LH side and RH side.
• The procedures listed below are for the LH side.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
   CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
2. REMOVE FRONT WHEEL 
3. REMOVE FRONT FENDER LINER LH (See  REMOVAL  ) 
4. REMOVE FRONT SPEED SENSOR LH 
   1. Detach the clamp and disconnect the connector.
      Fig 1: Locating Front Speed Sensor Connector (LH)

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. Remove the bolts and separate the speed sensor from the body.
      Fig 2: Locating Speed Sensor Bolts (LH)

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   3. Remove the bolt and speed sensor.
      NOTE: Keep the sensor tip and sensor installation hole free from foreign matter.
      Fig 3: Locating Speed Sensor Bolt (LH)

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002