FixVault
Home › Scion › 2007 › tC Base, Automatic › Repair and Diagnosis › Engine Mechanical › Auxiliary Emission Control Systems › Emission Control › Canister › Installation

Emission Control: Canister: Installation

  1. INSTALL CANISTER FILTER SUB-ASSEMBLY 
    1. Install the filter with the bolt.

      Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf) 

    2. Connect the 2 hoses.
  2. INSTALL CANISTER ASSEMBLY 
    1. Temporarily hook the claw of the canister bracket around the fuel tank hoses, and install the canister with the 2 bolts.

      Torque: 19 N*m (194 kgf*cm, 14 ft.*lbf) 

      Fig 1: Locating Canister Bracket Bolts
      G04865802Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the fuel vent hose.
      1. Connect the pipe to the fuel tube connector, as shown in A in the illustration. Then push up the retainer to lock the claws, as shown in B in the illustration.
        NOTE:
        • Check that there are no scratches or foreign objects around the connected part of the fuel tube connector and pipe before performing this work.
        • After connecting the fuel tank vent hose, check that the fuel tank vent hose is securely connected by pulling the fuel tube connector and pipe.
          Fig 2: Connecting Pipe To Fuel Tube Connector
          G04865803Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Connect the fuel tank vent hose.
      1. Align the fuel tank vent connector with the pipe, and then push in the fuel tank vent connector until the retainer makes a "click" sound to connect the fuel tank vent hose to the canister.
        Fig 3: Aligning Fuel Tank Vent Connector With Pipe
        G04865804Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        NOTE:
        • Check that there are no scratches or foreign objects around the connected part of the fuel tank vent connector and pipe before this work.
        • After connecting the fuel tank vent hose, check that the fuel tank vent hose is securely connected by pulling the quick connector.
    4. Install the fuel emission hose and 2 clamps.
    5. Install the leak detection pump connector.
      6. Fig 4: Locating Fuel Emission Hose And Clamps
      G04865805Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSTALL REAR SUSPENSION BRACE LOWER RH (See  INSTALLATION  ) 
  4. INSTALL NO. 1 FUEL TANK PROTECTOR (See  INSTALLATION  ) 
  5. INSTALL CENTER EXHAUST PIPE ASSEMBLY (See  INSTALLATION  ) 
  6. INSTALL FRONT FLOOR PANEL BRACE (See  INSTALLATION  ) 
  7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  8. PERFORM INITIALIZATION 
    1. Perform the initialization (see INITIALIZATION ).
      NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
  9. CHECK FOR EXHAUST GAS LEAKS 
About FixVault