Front Axle Hub Bolt: Replacement

HINT:

• Use the same procedures for the RH side and LH side.
• The procedures listed below are for the LH side.
• A bolt without a torque specification is shown in the standard bolt chart (see SPECIFIED TORQUE FOR STANDARD BOLTS ).

1. REMOVE FRONT WHEEL 
2. REMOVE FRONT DISC BRAKE CYLINDER ASSEMBLY 
   1. Remove the 2 bolts and disconnect the disc brake caliper assembly LH from the steering knuckle.
      NOTE:

      • Use a string or equivalent to keep the brake caliper from hanging down by the flexible hose.
      • The friction surface of the pad and disc must be free from oil, grease and paint.
      Fig 1: Locating Disc Brake Caliper Assembly Bolts

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. REMOVE FRONT DISC 
4. REMOVE FRONT AXLE HUB BOLT 
   1. Temporarily install the 2 hub nuts.
   2. Using SST and a hammer handle or an equivalent to hold the axle hub LH, remove the LH hub bolt.

      SST 09628-10011 

      Fig 2: Removing Front Axle Hub Bolt

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. INSTALL FRONT AXLE HUB BOLT 
   1. Install a washer and nut to a new LH hub bolt as shown in the illustration.
   2. Using a hammer handle or an equivalent to hold the axle hub LH, install the LH hub bolt by tightening the nut.
   Fig 3: Installing Front Axle Hub Bolt
   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. INSTALL FRONT DISC 
7. INSTALL FRONT DISC BRAKE CYLINDER ASSEMBLY 
   1. Install the disc brake caliper with the 2 bolts to the steering knuckle LH.

      Torque: 107 N*m (1090 kgf*cm, 79 in.*lbf) 

8. INSTALL FRONT WHEEL 

   Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf)