Front Speed Sensor: Removal

HINT:

• Use the same procedures for the LH side and RH side.
• The procedures listed below are for the LH side.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
   CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
   NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
2. REMOVE FRONT WHEEL 
3. REMOVE FRONT FENDER LINER LH  (See REMOVAL )
4. REMOVE FRONT SPEED SENSOR LH 
   1. Detach the clamp and disconnect the connector.
      Fig 1: Identifying Front Speed Sensor LH Connector

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. Remove the bolts and separate the speed sensor from the body.
      Fig 2: Identifying Speed Sensor Bolts

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   3. Remove the bolt and speed sensor.
      NOTE: Keep the sensor tip and sensor installation hole free from foreign matter.
   Fig 3: Identifying Speed Sensor Bolt

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002