Crankshaft Position Sensor: Removal

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE ENGINE UNDER COVER REAR RH
REMOVE FAN AND GENERATOR V BELT (See REMOVAL )
REMOVE GENERATOR ASSEMBLY
1. Disconnect the generator connector.
2. Remove the nut and disconnect the wire harness from terminal B.
3. Separate the 2 wire harness clamps.
  
  Fig 1: Locating Wire Harness Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Remove the 2 bolts and generator assembly.
  
  Fig 2: Locating Generator Assembly Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE CRANKSHAFT POSITION SENSOR
1. Disconnect the crankshaft position sensor connector.
2. Separate the crankshaft position sensor connector and wire harness.
3. Remove the bolt and crankshaft position sensor.
  
  Fig 3: Locating Crankshaft Position Sensor Connector And Crankshaft Position Sensor Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002