Park / Neutral Position Switch: Installation

INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY
1. Install the park/neutral position switch assembly onto the manual valve lever shaft.
2. Provisionally install the 2 bolts.
  
  Fig 1: Locating Bolts And Park/Neutral Position Switch Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Replace the lock plate with a new one and tighten the manual valve shaft nut.
  Torque: 6.9 N*m (70 kgf*cm, 61 in.*lbf)
  
  Fig 2: Identifying Manual Valve Shaft Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Provisionally install the control shaft lever.
5. Turn the control shaft lever counterclockwise until it stops, then turn it clockwise 2 notches.
  
  Fig 3: Turning Control Shaft Lever Counterclockwise
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Remove the control shaft lever.
7. Align the groove with the neutral basic line.
8. Hold the switch in this position and tighten the 2 bolts.
  Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
  
  Fig 4: Aligning Groove With Neutral Basic Line
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
9. Using a screwdriver, stake the nut with the lock plate.
  
  Fig 5: Staking Nut With Lock Plate
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
10. Install the control shaft lever with the nut.
  Torque: 13 N*m (133 kgf*cm, 10 ft.*lbf)
  
  Fig 6: Locating Control Shaft Lever Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
11. Install the transmission control cable assembly into the control shaft lever with the nut.
  Torque: 12 N*m (122 kgf*cm, 9 ft.*lbf)
  
  Fig 7: Locating Transmission Control Cable Assembly Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
12. Connect the connector to the park/neutral position switch assembly.
INSTALL NO. 2 BATTERY CARRIER (See INSTALLATION )
INSTALL BATTERY (See INSTALLATION )
INSPECT SHIFT LEVER POSITION (See ON-VEHICLE INSPECTION )
ADJUST SHIFT LEVER POSITION (See INSTALLATION )
INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY (See ON-VEHICLE INSPECTION )