Rear Speed Sensor: Installation

INSTALL REAR SPEED SENSOR
1. Wipe the sealant off the speed sensor installation surface using non-residue solvent.
  NOTE: Keep the sensor rotor free of foreign matter.
2. Install the speed sensor onto the rear axle hub in the highest possible installation position.
  HINT:
  
  The distance between the installation holes should be larger on the upper side than the lower side.
  
  Fig 1: Identifying Distance Between Installation Holes Should Be Larger On Upper Side And Lower Side
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Using SST and a press, install a new speed sensor into the rear axle hub until it is flush with the end surface of the axle hub.
  SST 09214-76011
  NOTE:
  - Do not use a hammer when installing.
  - Make sure that the sensor probe is free of foreign matter.
  - Press the speed sensor in slowly without turning it.
Fig 2: Pressing Speed Sensor Into Rear Axle Hub
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR AXLE HUB AND BEARING ASSEMBLY (See INSTALLATION )
INSPECT REAR AXLE HUB BEARING LOOSENESS (See ON-VEHICLE INSPECTION )
INSPECT REAR AXLE HUB RUNOUT (See ON-VEHICLE INSPECTION )
CONNECT SPEED SENSOR WIRE
1. Connect the speed sensor wire connector to the speed sensor.
Fig 3: Locating Skid Control Sensor Wire Connector
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR DISC (See INSTALLATION )
INSTALL REAR DISC BRAKE CALIPER ASSEMBLY (See INSTALLATION )
INSTALL PARKING BRAKE CABLE ASSEMBLY (See INSTALLATION )
INSTALL REAR FLOOR SIDE MEMBER COVER (See INSTALLATION )
ADJUST PARKING BRAKE LEVER TRAVEL (See ADJUSTMENT )
INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (See INSTALLATION )
INSTALL REAR WHEEL
Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf)
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.lbf)
INSPECT REAR WHEEL ALIGNMENT
(See INSPECTION )
CHECK VSC SENSOR SIGNAL
(See TEST MODE PROCEDURE )