Problem Symptoms Table
Use the table below to help determine the cause of a problem. The likely causes of the problem are indicated in descending order. Check each suspected area in order. Repair or replace faulty parts or perform adjustments as necessary.
NOTE:
When replacing the brake actuator assembly, sensor, etc., turn the ignition switch to OFF.
HINT:
- Inspect the fuse and relay before investigating the suspected areas as shown in the table below.
- Inspect each suspected area in order for the corresponding symptom.
Vehicle Stability Control System:
PROBLEM SYMPTOM CHART
| Symptom | Suspected Area | See |
|---|---|---|
| ABS and/or EBD does not operate | Check for DTCs again and make sure that the normal system code is output. | DTC CHECK / CLEAR |
| IG power source circuit | DTC C1241/41 LOW BATTERY POSITIVE VOLTAGE OR ABNORMALLY HIGH BATTERY POSITIVE VOLTAGE | |
| Front speed sensor circuit | DTC C0200/31 FRONT SPEED SENSOR RH CIRCUIT; DTC C0205/32 FRONT SPEED SENSOR LH CIRCUIT; DTC C1271/71 LOW OUTPUT SIGNAL OF FRONT SPEED SENSOR RH (TEST MODE DTC); DTC C1272/72 LOW OUTPUT SIGNAL OF FRONT SPEED SENSOR LH (TEST MODE DTC) | |
| Rear speed sensor circuit | DTC C0210/33 REAR SPEED SENSOR RH CIRCUIT; DTC C0215/34 REAR SPEED SENSOR LH CIRCUIT; DTC C1273/73 LOW OUTPUT SIGNAL OF REAR SPEED SENSOR RH (TEST MODE DTC); DTC C1274/74 LOW OUTPUT SIGNAL OF REAR SPEED SENSOR LH (TEST MODE DTC) | |
| Check the brake actuator assembly with the Techstream. (Check brake actuator assembly operation using the Active Test function.) If abnormal, check the hydraulic circuit for leaks. | BRAKE ACTUATOR | |
| If the symptoms still occur even after the above circuits in suspected areas have been inspected and proved to be normal, replace the brake actuator assembly (skid control ECU). | BRAKE ACTUATOR | |
| ABS and/or EBD does not operate efficiently | Check for DTCs again and make sure that the normal system code is output. | DTC CHECK / CLEAR |
| Front speed sensor circuit | DTC C0200/31 FRONT SPEED SENSOR RH CIRCUIT; DTC C0205/32 FRONT SPEED SENSOR LH CIRCUIT; DTC C1271/71 LOW OUTPUT SIGNAL OF FRONT SPEED SENSOR RH (TEST MODE DTC); DTC C1272/72 LOW OUTPUT SIGNAL OF FRONT SPEED SENSOR LH (TEST MODE DTC) | |
| Rear speed sensor circuit | DTC C0210/33 REAR SPEED SENSOR RH CIRCUIT; DTC C0215/34 REAR SPEED SENSOR LH CIRCUIT; DTC C1273/73 LOW OUTPUT SIGNAL OF REAR SPEED SENSOR RH (TEST MODE DTC); DTC C1274/74 LOW OUTPUT SIGNAL OF REAR SPEED SENSOR LH (TEST MODE DTC) | |
| Stop light switch circuit | DTC C1249/49 OPEN IN STOP LIGHT SWITCH CIRCUIT | |
| Check the brake actuator assembly with the Techstream. (Check brake actuator assembly operation using the Active Test function.) If abnormal, check the hydraulic circuit for leaks. | BRAKE ACTUATOR | |
| If the symptoms still occur even after the above circuits in suspected areas have been inspected and proved to be normal, replace the brake actuator assembly (skid control ECU). | BRAKE ACTUATOR | |
| ABS sensor DTC check cannot be done | Check for DTCs again and make sure that the normal system code is output. | DTC CHECK / CLEAR |
| TC and CG terminal circuit | TC AND CG TERMINAL CIRCUIT | |
| If the symptoms still occur even after the above circuit in the suspected area has been inspected and proved to be normal, replace the brake actuator assembly (skid control ECU). | BRAKE ACTUATOR | |
| ABS warning light abnormal (Remains on) | ABS warning light circuit | ABS WARNING LIGHT REMAINS ON |
| Brake actuator assembly (Skid control ECU) | BRAKE ACTUATOR | |
| ABS warning light abnormal (Does not come on) | ABS warning light circuit | ABS WARNING LIGHT DOES NOT COME ON |
| Brake actuator assembly (Skid control ECU) | BRAKE ACTUATOR | |
| Brake warning light abnormal (Remains on) | Brake warning light circuit | BRAKE WARNING LIGHT REMAINS ON |
| Brake actuator assembly (Skid control ECU) | BRAKE ACTUATOR | |
| Brake warning light abnormal (Does not come on) | Brake warning light circuit | BRAKE WARNING LIGHT DOES NOT COME ON |
| Brake actuator assembly (Skid control ECU) | BRAKE ACTUATOR | |
| Sensor check cannot be done | TS and CG terminal circuit | TS AND CG TERMINAL CIRCUIT |
| Brake actuator assembly (Skid control ECU) | BRAKE ACTUATOR |