FixVault
Home › Scion › 2008 › xD Automatic › Repair and Diagnosis › Transmission › Automatic Trans › U341E Automatic Transaxle › Shift Lever › Installation

Shift Lever: Installation

  1. INSTALL FLOOR SHIFT ASSEMBLY 
    1. Provisionally install the shift lever with the 4 bolts.
      NOTE: Do not jam the wiring of the indicator light or shift lock.
      Fig 1: Locating Shift Lever Bolts
      G05400016Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Tighten the 4 bolts in order, from A to D.

      Torque: 12 N*m (122 kgf*cm, 9 ft.*lbf) 

    3. Install the shift lock control computer connector and indicator light connector.
  2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY 
    1. Turn the nut on the control cable and push in the lock.
      Fig 2: Connecting Transmission Control Cable Assembly
      G04831151Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the control cable onto the shift lever retainer.
      CAUTION:
      • Install the cable with the projection of the cable outer facing upward.
      • After installing, check that the lock of the cable outer is protruding beyond portion A-A, as shown in the illustration.
        Fig 3: Identifying Projection Of Transmission Control Cable
        G04831152Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Connect the control cable to the shift lever.
      NOTE: Connect the control cable so that the adjusting mechanism lock of the control cable is installed on the left side of the vehicle.
      Fig 4: Locating Transmission Control Cable
      G04831143Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSPECT SHIFT LEVER POSITION  (See REMOVAL  )
  4. ADJUST SHIFT LEVER POSITION 
    1. Shift the shift lever to the N position.
    2. Slide the adjuster case cover in the direction shown in the illustration and pull out the lock piece.
      3. Fig 5: Sliding Adjuster Case Cover And Pulling Out Lock Piece
      G05400020Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Gently pull the cable rod toward the rear of the vehicle by hand to pull the cable taut.
    4. Press the lock piece into the adjuster case and lock it.
      Fig 6: Pressing Lock Piece Into Adjuster Case
      G05400021Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Slide the cover in the direction shown in the illustration.
      NOTE: Slide the cover past the protrusion on the lock piece.
      Fig 7: Sliding Adjuster Case Cover
      G05400022Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    6. Inspect the operation after the adjustment.
  5. INSTALL FRONT CONSOLE BOX  (See INSTALLATION )
  6. INSTALL REAR CONSOLE BOX SUB-ASSEMBLY  (See INSTALLATION )
  7. INSTALL CONSOLE BOX CARPET  (See INSTALLATION )
  8. INSTALL REAR CONSOLE BOX COVER  (See INSTALLATION )
  9. INSTALL UPPER CONSOLE PANEL  (See INSTALLATION )
  10. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY 
    1. Install the shift lever knob sub-assembly onto the shift lever.
About FixVault