FixVault
Home › Scion › 2009 › tC Automatic › Repair and Diagnosis › Suspension › Front Suspension › Front Stabilizer Bar › Installation

Front Stabilizer Bar: Installation

  1. INSTALL FRONT STABILIZER BAR 
  2. INSTALL FRONT NO. 1 STABILIZER BAR BUSH 
    1. Install the bushes to the outer side of the bush stopper on the stabilizer bar.
      NOTE: Place the cutout of the stabilizer bush facing the rear side.
      Fig 1: Locating Front No. 1 Stabilizer Bar Bush
      G05540112Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSTALL FRONT NO. 1 STABILIZER BRACKET LH 
    1. Install the No. 1 stabilizer bracket to the suspension crossmember with the 2 bolts.

      Torque: 19 N*m (194 kgf*cm, 14 ft.*lbf) 

      Fig 2: Locating Stabilizer Bracket To Suspension Crossmember Bolts
      G05540110Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. INSTALL FRONT NO. 1 STABILIZER BRACKET RH 

    HINT:

    Use the same procedures described for the LH side.

  5. INSTALL FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY  (See INSTALLATION )
  6. INSTALL NO. 1 HOOK  (See INSTALLATION )
  7. CONNECT FRONT SUSPENSION NO. 1 LOWER ARM SUB-ASSEMBLY LH  (See INSTALLATION  )
  8. CONNECT FRONT SUSPENSION NO. 1 LOWER ARM SUB-ASSEMBLY RH 

    HINT:

    Use the same procedures described for LH side.

  9. INSTALL FRONT STABILIZER LINK ASSEMBLY LH 
  10. INSTALL FRONT STABILIZER LINK ASSEMBLY RH 
  11. CONNECT PRESSURE FEED TUBE ASSEMBLY  (See INSTALLATION )
  12. CONNECT TIE ROD END SUB-ASSEMBLY LH 
    1. Connect the tie rod end LH (see INSTALLATION ).
  13. CONNECT TIE ROD END SUB-ASSEMBLY RH 

    HINT:

    Use the same procedures described for LH side.

  14. INSTALL CENTER EXHAUST PIPE ASSEMBLY  (See INSTALLATION )
  15. INSTALL FRONT FLOOR PANEL BRACE  (See INSTALLATION )
  16. INSTALL FRONT WHEEL 
  17. CONNECT NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY 
  18. CONNECT NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY  (See INSTALLATION )
  19. INSTALL COLUMN HOLE COVER SILENCER SHEET 
    1. Install the silencer sheet (see INSTALLATION ).
  20. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY 
  21. ADD POWER STEERING FLUID 
  22. BLEED POWER STEERING FLUID 
    1. Bleed the power steering fluid (See ON-VEHICLE INSPECTION ).
  23. CHECK POWER STEERING FLUID LEVEL IN RESERVOIR 
    1. Check the power steering fluid level in reservoir (See ON-VEHICLE INSPECTION ).
  24. CHECK POWER STEERING FLUID LEAKS 
  25. INSPECT HOOD SUB-ASSEMBLY 
  26. ADJUST HOOD SUB-ASSEMBLY  (See ADJUSTMENT )
  27. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT 
    1. Inspect and adjust the front wheel alignment (see ADJUSTMENT  ).
  28. INSTALL ENGINE UNDER COVER LH 
  29. INSTALL ENGINE UNDER COVER RH 
About FixVault