Rear Combination Light Assembly: Installation

WARNING: This page is about a different car, the 2008 Scion xB. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL REAR COMBINATION LIGHT BULB
1. Install the rear combination light bulb into the light socket.
2. Turn the rear combination light socket and bulb, in the direction indicated by the arrow in the illustration, to install them.
  
  Fig 1: Installing Rear Combination Light Bulb
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR TURN SIGNAL LIGHT BULB
1. Install the rear turn signal light bulb into the light socket.
2. Turn the rear turn signal light socket and bulb, in the direction indicated by the arrow in the illustration, to install them.
  
  Fig 2: Installing Rear Turn Signal Light Bulb
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR COMBINATION LIGHT LENS GASKET
1. Install a new rear combination light lens gasket.
  
  Fig 3: Locating & Installing Rear Combination Light Lens Gasket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR COMBINATION LIGHT ASSEMBLY
1. Install the rear combination light onto the vehicle.
  
  Fig 4: Identifying & Installing Rear Combination Light
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the connector.
3. Install the 3 nuts.
  Torque: 3.2 N*m (32 kgf*cm, 28 in.*lbf)
  
  Fig 5: Locating & Installing 3 Rear Combination Light Assembly Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR COMBINATION LIGHT SERVICE COVER
1. Engage the 7 claws and install the rear combination light service cover.
  
  Fig 6: Identifying Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002