Stop Light Switch: Installation

WARNING: This page is about a different car, the 2008 Scion xB. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL STOP LIGHT SWITCH
1. Install the stop light switch into the adjuster until it slightly touches the brake pedal.
  NOTE: Do not depress the brake pedal.
  
  Fig 1: Identifying Stop Light Switch And Brake Pedal
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  1. Make a quarter turn clockwise to install the stop light switch
  NOTE: Do not depress the brake pedal.
  
  HINT:
  
  The turning torque for installing the stop light switch is as below.
  
  Torque: 1.5 N*m (15 kgf*cm, 13 in.*lbf) or less
  
  Fig 2: Installing Stop Light Switch
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Check the stop light switch clearance.
  Stop light switch clearance:
  
  1.5 to 2.5 mm (0.059 to 0.098 in.)
3. Connect the stop light switch connector to the stop light switch.
  
  Fig 3: Locating & Installing Stop Light Switch Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002