Inspection Procedure

1. Disconnect the A36 connector from the ECM.
2. Measure the resistance according to the value(s) in the table below.

   Standard resistance 

   TESTER CONNECTION SPECIFIED CONDITION
   
   

   Tester Connection	Condition	Specified Condition
   A36-27 (TC) - C14-13 (TC) C14-4 (CG) - Body ground	Always	Below 1 Ω
   C14-13 (TC) - Body ground	Always	10 kΩ or higher

3. Reconnect the connector from the ECM.

Fig 1: Identifying C14 And A36 Connectors Terminals

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG : REPAIR OR REPLACE HARNESS OR CONNECTOR OR EACH ECU 

OK : PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN  PROBLEM SYMPTOMS TABLE  .