Rear Axle Hub: Installation

HINT:

• Use the same procedures for the RH side and LH side.
• The procedures listed below are for the LH side.

1. INSTALL REAR DISC BRAKE DUST COVER SUB-ASSEMBLY 
2. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY 
   Fig 1: Locating & Installing 4 Rear Axle Hub Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   1. Install the hub and bearing assembly with the 4 bolts.

      Torque: 90 N*m (918 kgf*cm, 67 ft.*lbf) 

      NOTE: Do not place the hub and bearing's magnet rotor side so that it is facing downward, and do not allow the magnet rotor side to become damaged or contact foreign matter.
3. INSTALL SKID CONTROL SENSOR WIRE  (See INSTALLATION )
4. INSPECT REAR AXLE HUB BEARING LOOSENESS  (See ON-VEHICLE INSPECTION  )
5. INSPECT REAR AXLE HUB RUNOUT  (See ON-VEHICLE INSPECTION  )
6. INSTALL REAR DISC  (See INSTALLATION )
7. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY 
   Fig 2: Locating Rear Disc Brake Caliper Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   1. Install the rear disc brake caliper with the 2 bolts.

      Torque: 57 N*m (586 kgf*cm, 42 ft.*lbf) 

8. INSTALL NO. 3 PARKING BRAKE CABLE ASSEMBLY  (See INSTALLATION )
9. INSPECT PARKING BRAKE LEVER TRAVEL  (See ADJUSTMENT )
10. ADJUST PARKING BRAKE LEVER TRAVEL  (See ADJUSTMENT )
11. INSTALL REAR FLOOR SIDE MEMBER COVER  (See INSTALLATION )
12. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY  (See INSTALLATION )
13. INSTALL REAR WHEEL 

    Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf) 

14. INSPECT REAR WHEEL ALIGNMENT 
    1. Inspect the rear wheel alignment (See INSPECTION ).
15. CHECK VSC SENSOR SIGNAL 

    (See CHECK FOR INTERMITTENT PROBLEMS )