Inspection Procedure

WARNING: This page is about a different car, the 2008 Scion xB. However, it is still accessible from the selected car via links, so may be relevant.

CHECK HARNESS AND CONNECTOR (DLC3 - ECM AND BODY GROUND)

Disconnect the A36 connector from the ECM.

Measure the resistance according to the value(s) in the table below.

Standard resistance

TESTER CONNECTION SPECIFIED CONDITION

Tester Connection	Condition	Specified Condition
A36-27 (TC) - C14-13 (TC) C14-4 (CG) - Body ground	Always	Below 1 Ω
C14-13 (TC) - Body ground	Always	10 kΩ or higher

Reconnect the connector from the ECM.

Fig 1: Identifying C14 And A36 Connectors Terminals

NG : REPAIR OR REPLACE HARNESS OR CONNECTOR OR EACH ECU

OK : PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE .